Vehicle Wiring Details for your
2004-2007 Ford Focus Wiring Diagram | Printer Friendly
Version |  | | Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2007 Ford Focus . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
| | |  | | PART | COLOR | LOCATION | | 12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS | | STARTER | GRAY/BLACK (+) | @ IGNITION SWITCH HARNESS | | STARTER 2 | N/A | | | IGNITION 1 | GREEN/YELLOW (+) | @ IGNITION SWITCH HARNESS | | IGNITION 2 | N/A | | | IGNITION 3 | N/A | | | ACCESSORY/HEATER BLOWER 1 | YELLOW (+) | @ IGNITION SWITCH HARNESS | | ACCESSORY/HEATER BLOWER 2 | N/A | | | KEYSENSE | RED/BLACK (-) | @ IGNITION SWITCH HARNESS | | PARKING LIGHTS ( - ) | N/A | | | PARKING LIGHTS ( + ) | ORANGE/YELLOW (+) | @ HEADLIGHT SWITCH or GEM, TAN Plug, Pin 14, See NOTE #5 | | POWER LOCK | BLACK/RED (TYPE B) | IN DRIVERS KICK PANEL or GEM, GRAY Plug, Pin 15, See NOTE #5 | | POWER UNLOCK | BLACK/YELLOW (TYPE B) | IN DRIVERS KICK PANEL or GRAY Plug, Pin 21, See NOTE #5 | | DOOR TRIGGER | See NOTE #2 | @ GEM, See NOTE #5 | | DOMELIGHT SUPERVISION | BLACK/BLUE (-), (Requires Part #775 Relay) | @ GEM, GREY Plug, Pin 3, See NOTE #5 | | TRUNK RELEASE | BLACK/YELLOW (-), (Requires Part #775 Relay) | @ TRUNK RELEASE SWITCH | | SLIDING POWER DOOR | N/A | | | HORN | BLACK/BLUE (-) or BLACK/GREEN (-) | @ STEERING COLUMN HARNESS or GEM, BROWN Plug, Pin 14, See NOTE #5 | | TACH | BLACK/GREEN or BLACK/ORANGE (AC) | @ IGNITON COIL | | WAIT TO START LIGHT | N/A | | | BRAKE | GREEN/RED (+) | @ GEM, TAN Plug, Pin 9, See NOTE #5 | | FACTORY ALARM DISARM | BLACK/WHITE (-) | @ GEM, GRAY Plug, Pin 14, See NOTE #5 | | ANTI-THEFT | FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1 | @ IGNITION SWITCH TUMBLER | | EXTRA INFORMATION | | NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: This vehicle has (4) door trigger wires, the DRIVERS DOOR is a YELLOW/BLACK (-) in a TAN Plug, Pin 22, the PASSENGER DOOR is a BLACK/BLUE (-) TAN Plug, Pin 21, the DRIVERS REAR DOOR is a BLACK/ORANGE (-) in a WHITE Plug, Pin 15 and the PASSENGER REAR DOOR is a BLACK/GREEN (-) in a GRAY Plug, Pin 15. When connecting to an ALARM SYSTEM use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #3: The IGNITION SWITCH MUST be turned on before the Brake wire will test properly. NOTE #4: The FACTORY KEYLESS ENTRY Module (if so equipped) is located behind and to the right of the GLOVE BOX. NOTE #5: The GEM (Generic Electronic Module) is located above the PASSENGER KICK PANEL. | | | | | | Posted by: cuttingtrim.blogspot.com
Source: http://www.commandocaralarms.com/wiring/2004-2007/ford/focus/773.html